In my last blog entry I told of how I came up on these Power Wands. I can't really explain it much other than to say that I wanted to do a real wand. I then go about my business. At some future time, the answer just pops into my head. That is the nearest thing I can come up with. I've done this for a long time in solving engineering problems and other things. So now I had a shape and a material that I liked. Next came the shaping needed and I had no experience in doing any of it. I knew that selenite is soft. Soft enough to scratch with your finger nail which gives it on the Mohs scale of a little over a 2. I tried using a Dremmel tool with a sanding disk and the results were very dusty and imprecise. It did work with a learning curve involved. I produced a general shape. I also found out that Selenite is water soluble and I used this property to use water as a polishing agent to get a really smooth surface. I also learned that i could cut it with a mitter saw tool I had in my garage and it would give me the right angles that I needed at the ends. I was satisfied with the shape and looks of it. I did not pay attention to a perfect finish as I do not believe it is necessary for the energies to flow. I also prefer to work with raw shapes in crystals. Natures beauty. In doing research, I found out that copper has amplifying properties when it is in contact with selenite. Immediately I thought of antennas. I thought that maybe I wanted to use a copper sheet to cover one side of the selenite. I quickly found it expensive and then How would it be attached? I hit on a piece of solid copper electrical wire and quickly went to work. I tried to flatten out the wire and it was not aesthetically pleasing and the glue just refused to work. After many tries I decided to use the springiness of the wire to hold it on the crystal. Copper is soft but the more you work it the harder it becomes. To soften it again you must heat it. It took a while to figure out how to bend it to the correct shape and this is what I had.

As you can see I built a nice wood box to put it in. This box is painted in a gold color paint and felt is used on the inside to give it a plush finish to the wands. Next came the testing of it to see if I was doing it right. I knew that this type of wand was to be held with the left hand in a grip but nit too hard. Like so.

I felt a tingly sensation running up my arm. I thought well, I must be going south. But It was so every time I did that. I took the wand places with me even to a spiritual seminar and let people hold it. They reported similar effects on them. So Then was the question: what sort of energy? I then decided that programming was in order before any further use. It would be a filter of sorts to allow only beneficial energies through. This is the unseen part that involves a human mind in this system. I set the wand out in the sunlight for a few hours and it got very hot to the touch. It kind of glowed. I used some of the research of Marcel Vogel and used my breath to clear it and then set the intention to heal and to use only Universal Divine Love, the glue of the Universe; like so.

At that point I knew that these wands could not be used to hurt but to heal. That is very important to me or I would not be doing this or offering to other people to use. It would defeat the purpose. ...to be continued.